Brother je razvio i usavršio potpuno nov i revolucionaran put za definirati slike na površinu gumenog žiga.. Poslije kreiranja slike na računalu i ubacivanja teksta, ostatak procesa je u nekoliko minuta gotov. Tinta nikad ne dodiruje Vaše prste... ovaj proces je apsolutno čist, suh, i siguran za okruženje.
Pokrenite program Stamp Editor na vašem PC ili MAC i kreirajte sliku koju želite.
The Stampcreator PROTM will instantly transfer the image you have prepared on your computer screen onto a transparent film, which will be loaded automatically from the magazine tray inside. 600 dpi thermal transfer printing will reproduce every detail from your graphics. Open the window and you will see the film (positive master) for your stamp positioned above the Xenon Flash Assembly.
Utoru za izradu žiga sa Xenon bljeskalicom. Pozicija za stavljanje novog žiga
Kada se vrata utora za izradu žiga zatvore Xenon bljeskalica automatski okida.
Lice žiga je napravljeno od svijetlosno osjetljivog gumenog materijala specijalno razvijenog za Brother StampCreator PRO. Light from the Xenon flash causes millions of micro-pores in the stamp surface to close. Only pores protected by the black printing on the positive master film will remain open.
Attaching the stamp handle causes the ink pack embedded in the stamper base to open. Keep the stamp upright for a few minutes for all the ink to drain. After a brief cure time, the ink is absorbed by the stamp material and the stamp will be ready to use. The ID label can be printed in the same way by the Stampcreator PROTM and attached to the handle for proper identitication.
